![]() The only parameter changed is in the Touch Press Event - Send key value is selected. Its background has been set to Picture 0. ![]() ![]() There is only one page and it is referenced as 0.See the section ' The Graphics and Image Cropping'. There are only three full screen graphics loaded and they are referenced as Pictures 0, 1 and 2.The following image should appear on the screen.When the software is installed, remove the SD Card and power cycle the display again.The display should immediately begin to install the firmware.Insert the SD Card into the slot and power cycle the display.Ensure that there is no other.tft file on the SD Card Copy the.tft file to a FAT32 formatted SD Card.4.3' Nextion display: 272x480Example.tft.2.4' Nextion display 240x320Example.tft.In the firmware folder in the library you will find the.tft files:.You already seen that by using our header file lcd.h, you can connect your 16×2 LCD to any of the output pins of the microcontroller. By Ligo George ATMEL AVR, Tutorials Atmega32, Atmel, Atmel Studio. Interfacing LCD with Atmega32 Microcontroller using Atmel Studio.
0 Comments
Leave a Reply. |